PLANUTILITIESPAGE

Draw a pline around a closed area the select this pline the function calculates the area converts into square meters then places the answer as text (current setting) at selected point.

Making of single and cavity walls on plan, Two routines Plain single walls and Cavity walls.

Openings in cavity walls. - Plain openings (kcavopen) - Windows (kcavwin) - Single doors (kcavdoor) - Double doors (kcavdbldoor)

Function for placing 'single thickness walls' (pair of double lines) on drawing and trimming the junctions. Uses current layer.

single wall routines 9 number functions - 1. Single skin walls - 2. Clean up corner junctions - 3. Clean up T junctions - 4 . Plain opening - 5. Single door - 6. Double doors - 7. Framed opening - 8. Exinting window - 9. New window - Uses current layer.

Places one of three diferent types of front entrance frames on plan single or double doors with single or double sidelights. - 1. Double doors two sidelights - 2. Single doors two sidelights - 3. Single doors single sidelight.

This routine places part open timber folding door on plan between openings.

Hatches between two lines at 45 degrees from end to end, allows for vertical hatching, works left to right, bottom to top.

One routine draws shaped insulation between two points at user given thickness.

Fabric covered folding doors (Monofold), places part open fabric covered folding door on plan between two points

For putting a simple single half flight staircase with break line on drawings. Places stair run between two parallel lines user enters going and No of steps.

Intended for putting bench seating against walls, 50mm back rail with 300mm wide bench. continous trims around corners, esc to finish. Draws unit in line format on drawing

Intended for putting shelf and worktop against walls, 300mm shelf over 600mm wide bench unit. continous trims around corners, esc to finish.

Places a row of wash basins on drawing, using small, medium or inset basin types. Spacing of basins can be from close coupled to user entered space. Inset uses block of basin and draws line for bench for inset basin on drawing.

Intended for a single putting slab urinal against wall to any user selected length. Draws unit in line format on drawing.

Draws roof trusses spaced at 600mm on plan drawing. user selects ends of rafter, direction and distance along roof.

Puts hip trusses spaced at 600mm on plan drawing - ; user selects top of hip, direction and distance.

Draws noggins, walls braces etc between roof trusses spaced at 600mm on plan drawing - user selects start rafter, width of noggin, direction and distance along roof.