There is no rewiring required for this mod other than inserting a power diode within the lighting harness.

1 x 1N5408(3A 1000V) power diode is required for this mod.

At this stage it is a good idea to either remove the battery connections or use a cordless soldering iron to solder the diode into place. Removing the plastic cover beneath the steering column will allow you to isolate the required connector. A single screw located near the lower left of the plastic and the bonnet release piece will need to be removed. Once the Combination switch connector has been located which is blue in colour, insert the power diode into the relevant location and solder into position.

Connector circuit diagram pic

Actual picture of connector and diode in position

[Home] [Mods] [Window Closure] [Diode Pass Flash] [Sleepy Eye] [Throttle Body] [Short Shift] [Mods page 2] [Web Links] [Photo Gallery] [Paint Codes]