Parts List:
Here are the parts that I used;
| Part | Quantity | From |
| Fibreglass Poles | 4 | http://stores.ebay.co.uk/AMTOOLS |
| RG58/U Coax | 20ft | anywhere |
| Twin Black & Red 10amp CB Power cable | Maplins | |
| 100mm Cable ties - black | 300 | ScrewFix |
| 200mm Cable Ties - black | 50 | ScrewFix |
| 2" X 4" Plastic box | 1 | http://www.sycomcomp.co.uk/ |
| PL259 Connector | 1 | anywhere |
| 9" Square MDF | 1 | anywhere |
| Aluminium Tube 1/2 " diameter | 30cms | anywhere |
| 15amp terminal blocks | 1 x 12 way | anywhere |
| Fibreglass Poles for junction box ( 1 meter long ) | 1 | anywhere |
| 5mm self taping screws | 10 | anywhere |
| Re the 9" Square MDF, I cut it out from a bigger bit, then drilled a hole in the middle to match the mast diameter - I then painted the square to waterproof it. | Have another look at the picture. | |
| Aluminium tupe cut into 4" sections then split down the middle and to fix fibreglass poles on 9" square MDF | Have another look at the picture. | |
| You will need a good roll of solder, wire cutters & strippers, a drill and 3mm drill bits and a bit of TLC during the process | ||
| I used the large qty of cable ties to fix the cables to the fibreglass poles. The large number was used as there was a lot of adjustment to be done in the first instance - so I went thru a few. The larger ties were used as anchor supports and the smaller ties to fix the cables. | ||
| Dave's site shows the ends of each loop joined. My loops are not joined. | Have a look at the picture. | |
| I started with the 20M band first then working my way thru to the 10M band. There is a little bit of adjustment to be done on each band when you add another. |
Unless otherwise stated the contents of this web site are © 2005 M0MRR