The HF Regen Transceiver
40M REGENERATIVE RECEIVER
The regen receiver is an amazing piece of electronics. If you have never tried to build anything ever this is something you have to try! Various circuits are available on the internet (see links on the left) but I offer you my own humble version based heavily on similar circuits that have been published over the last 30 years or more.
The circuit described
may not be the answer to the purist: it will radiate a little RF
on the frequency to which it is tuned so avoid using one when you
have nearby hams trying to work DX. Having said that it works well,
is sensitive and produces decent level signals on SSB and CW into a small
WHAT RESULTS CAN BE ACHIEVED WITH 9 PARTS?
With the circuit shown the receiver can pull in stations well from all over Europe on 40m with ease. It will be overloaded if there are strong AM stations nearby e.g. in the 41m broadcast band at night. Minimum discernable signal level is a credible -85 to -90dBm - not bad for something this simple!
L1 is a small T50-6 (red) toroid with around 18-20 turns on the main winding connected to the FET with a single turn coupling loop for the antenna connection. C1 is adjusted to set the radio into the 40m band and C2 then acts as a fine tune within the band. You can check the frequency by listening to the frequency radiated when the stage is in oscillation. By changing L1 and C1/2 other HF bands like 80, 30 or 20m can be covered. Experiment! C4 is adjusted to get the circuit to just regenerate. There are no decouplers: these did not seem to matter, so were left out for simplicity.
MAKING IT TRANSCEIVE?
This is where the REAL fun starts! By switching the same MPF102 FET across to a few more parts (as was done by W2UW) this can be made into a single FET transceiver, albiet with very low power around 20mW. W2UW has achieved 2 Canadian provinces and 17 US states with the rig shown here.
Trying something very
similar is my next challenge, so watch this space for more information
about the 1-transistor/FET rig.
W2UW's circuit (copied from GQRP SPRAT magazine)
LINKSSimple homebuilt radio projects
GQRP Club and SPRAT
Return to index page