|
| | Ok for a change this mod is quite tricky if in the wrong hands. Experience
with a dremel is required.
Materials:
 | Screw Driver
| 6mm *2 bolts
| Oil Filter Wrench
| Socket Wrench and Socket
| Red Marker
| Dremel
| Dremel Cutting Disk Set
| Safety Goggles
| M Grade Sand Paper |
| | | | | | | |
Procedure:
- First remove flywheel cover and flywheel
- Get the cutting disks and dremel ready up to rpm about setting five for a
plug in and for recharge one its 2
- Now, use your pen and make a mark about 1/16 of an inch from the bottom on
the two middle long fins. Do the same on the other side with the two middle
long fins.
- Slowly make a small cut where your red marking is on the
fins. One fin at a time.
- Try not to cut any other fins!!
- Now repeat the process and cut off the other middle fin. Do the same for
the other side's two middle fins.
- If your cuts aren't straight then sand them and use a level to check they
are straight.
- Spinning it in the air. It should spin smoothly and not wobble. If it
wobbles, then you have not done this correctly.
- Further lightening ; take off the two middle short fins on both the top
and bottom the flywheel By the magnets. Same procedure as above.
|
