Ad.timi

The Perfect place to go for Ped stuff!!

click above!!

Advance Timing

Materials:

	Screw Driver
	Socket Wrench & Socket
	Oil Filter Wrench
	Pair of 6mm Bolts
	Pair of Side cutters

1. Firstly, remove flywheel cover , with pull start attached.

2. Make sure the piston is at top dead center.

3. Put a mark on the flywheel outer circle at top dead center across the flywheel and the housing (red marker). Now put a mark not more than 8mm further down on the outer housing of the flywheel (black marker).

4. Remove the hex nut in the middle of the flywheel.

5. Remove the flywheel.

6. Remove the key (do not loose)

7. Then put the flywheel back on, and put the red line in line with black one.

8. Re-attach everything.

Any problems with this site or improvements should be sent to John. I am not responsible for anything that you do to your goped through my site, these instructions are correct so at least follow them!!