These images show the Peg Material I've made. This is multiple laminations of
Unidirectional Carbon with a Carbon Cloth front and back and a Kevlar central
layer. The pegs are laid up
in a trough to get the finger side curvature. Peel Ply is used on top of
the lay-up to allow any excess Epoxy out.
Cut to desired length and sand
ends to have a sub 1g peg.
A end on view, showing the built in finger side curve (The light line in the
centre is the Kevlar layer)
And another shot of the curve
<< Back to Catalogue - Pegs Page
