Extending the Rx. coverage of the IC2SE and IC4SE
            =================================================

It is possible to extend the receiver coverage of both of the above radios
without removing the covers!

With the rig turned off, but beep enabled, hold down LAMP, FUNC and V/M
buttons while simultaneously turning on the rig. Keep all 3 buttons pressed.
The display  will fill up with all sections on, then there will be a beep, a
longish gap and another beep. Once the second beep is over, release the
buttons.
Lo and behold, you now have coverage of any freq from 0 to 1300 MHz, except,
of course, that the VCO cannot cover the entire range. For example, the 4SE
will cover approximately 380 to 480MHz plus 805 to about 930MHz.

Brian G8SEZ @ GB7ZPU

(Downloaded from GB7SYP)