FT 411 OUT OF BAND MODIFICATIONS.
                ---------------------------------

1) Open the front cover.
2) Locate the C.P.U. unit (it is located on the front cover).
3) Locate Jumpers 1, 2, 3 and 4 , These are the band setting jumpers.
4) Jumpers No. 1, 2 and 4 should be disconnected,and jumper No. 3 should be
   connected.
5) Close the radio.
6) Apply power to the radio and turn it on.  The display will initialize with
   memory No. 1 flashing and the frequency display will show 1.000.
7) Now, adjust the display to the desired lowest receive frequency. When
   done, press VFO. The memory CH will now show 2 flashing.
8) Adjust the display to the desired highest receive frequency. When done,
   press VFO. The memory CH will now show 3 flashing.
9) Adjust the display to the desired lowest transmit frequency. When done,
   press VFO. The memory CH will now show 4 flashing.
10) Adjust the display to the desired highest transmit frequency. When done,
    press VFO.

The rig is now set for your programmed band on transmit and receive.

COMMENTS
--------

1) If after programming the rig as above, you wish to change it to other
   ranges you will have to open the rig again and disconnect jumper No. 3.
   Then apply power to the radio and turn it on and off. Open it again,
   connect jumper No. 3 and continue from step 5.

73 Aviad 4X6TL @ 4Z4SV

(Downloaded from GB7SYP)