DJ-560T frequency expansion
                          ===========================

    The  following  modification  to the Alinco DJ-560T will  enable  it  to
    transmit out of band. It may also enable cross-band repeat.

    1. Turn power off, remove battery and antenna.

    2. Unscrew   stainless  steel  battery  connector  plate.  This  is  the
       rectangular  s/s plate found at the bottom of the unit and is held in
       place with (4) small phillips head screws.

    3. Unscrew  the one black headed, phillips screw immediately adjacent to
       the BNC.

    4. Carefully remove the grey DIAL, UHF and VHF plastic knobs.

    5. Unscrew  the  lock ring nuts that are found under each of  the  three
       sets of knobs.

    6. Gently remove the plastic top cover on the unit.

    7  Unscrew  the (4) black head phillips screws that hold the body halves
       together.

    8. Place  the  unit face down on a work surface that is covered  with  a
       towel  or a similar soft cloth. This will protect the unit from being
       marred while you work on it.

    9. Gently separate the two body halves about 1/2" to 3/4".

   10. Cut the ORANGE wire loop and reseal the exposed ends with heat shrink
       tubing.
       (Note: if  your DJ-560T is serial numbered from #0636-0705, the  loop
              will  be  YELLOW in color! However, which ever the color,  cut
              only the loop! It will be the only loop to be found!)

   11. Reassemble the unit in the reverse order of the above instructions.

   12. Reset  the  CPU by holding the 'F' key (above the PTT key)  down  and
       turning on the unit.

    This  mod  was  supplied by a major amateur radio dealer.  Several  have
    tried  it and it works. One caution: The black screws that hold the back
    on  are  very  flimsy. Use a screwdriver of exactly the  right  size  or
    you're likely to strip the heads.

    Taken from a USENET posting.

    Note:  Transmitting  out of band is a serious offence and carries  heavy
    ====   penalties.

    Information provided by John G1YYH @ GB7NWP

    ========================================================================


    (Downloaded from GB7SYP)