HERE IS THE MODIFICATION FOR THE ALINCO DJ-F1T 2 METER HT
           =========================================================

    1. REMOVE 5 SCREWS; 4 FROM THE BACK AND ONE FROM THE SIDE JUST BELOW THE
       PTT SWITCH.

    2. OPEN THE UNIT BY HOLDING THE BATTERY RELEASE SWITCH ON THE BOTTOM AND
       PUSHING UP ON THE BNC CONNECTOR (CAREFULLY). (THESE INSTRUCTIONS  FOR
       OPENING THE UNIT CAN BE FOUND IN THE BACK OF THE OWNER'S MANUAL.)

    3. WITH  THE UNIT OPEN AND THE MAIN UNIT (THE ONE CONTAINING THE CPU) ON
       YOUR  RIGHT, YOU WILL NOTICE TWO SMALL JUMPER WIRES: ONE RED AND  ONE
       BLUE.   SNIP  THESE  WIRES  CAREFULLY,  AND  PLACE  SMALL  PIECES  OF
       ELECTRICAL TAPE OVER THE ENDS.

    4. CLOSE UNIT AND REPLACE SCREWS.

    5. REPLACE BATTERY.

    6. RESET CPU BY TURNING POWER WHILE HOLDING DOWN "FUNCTION" BUTTON.
       (NOTE: YOU MAY WISH TO RECORD YOUR MEMORY SETTINGS FIRST!)

    7. YOUR  DJ-F1T  WILL  NOW TRANSMIT OUT OF BAND: YOU  MUST  HAVE  PROPER
       AUTHORIZATION OR RISK LOSS OF YOUR LICENSE OR FINE!!!

    8. BY PRESSING THE "B" BUTTON WHILE IN THE VFO MODE, YOUR RADIO WILL NOW
       TOGGLE BETWEEN AIRCRAFT BAND (AM) AND 2 METERS!!!

    I HAVE MADE THIS MODIFICATION ON TWO UNITS AND THEY WORK FLAWLESSLY.
    I ASSUME, HOWEVER, NO RESPONSIBILITY FOR YOUR WORK OR EQUIPMENT.
    EXERCISE APPROPRIATE CARE, AND YOU SHOULD HAVE NO PROBLEMS.
    THE WHOLE THING TOOK ME LESS THAN 5 MINUTES.

    ========================================================================


    (Downloaded from GB7SYP)